Every home has a light that flickers now and then. Most of the time the cause is minor. Occasionally it is the first sign of a connection that is overheating.
Usually harmless
- A loose or failing bulb. Tighten it or swap it.
- An LED bulb on an old dimmer. Incandescent-era dimmers often cause shimmer or flicker; an LED-rated dimmer fixes it.
- A brief dip when a large motor starts, such as the air conditioner.
Worth a closer look
- Flicker limited to one fixture or one circuit, which suggests a loose connection at a switch, fixture or splice.
- Lights that dim noticeably whenever an appliance runs, which can mean an overloaded circuit.
Call promptly
- Flicker across several rooms or the whole house.
- Lights that get brighter as well as dimmer.
- Flicker along with buzzing, warm cover plates or a burning smell.
Those symptoms point toward a loose neutral or a failing connection at the panel, meter or service. A loose neutral lets voltage swing high and low, which destroys electronics and can overheat wiring. Treat it as a job for an emergency electrician.
What the electrician does
Troubleshooting starts at the panel: voltage measured under load on both legs, connections checked for heat with a thermal camera, and the neutral and ground inspected. If the problem is on the utility side of the meter, we document it so the utility will act.
Is it the utility?
If neighbors see the same flicker at the same time, call your utility. If it is only your house, it is your wiring or your service connection, and an electrical repair is the next step.